Free Idaho CDL Hazmat Endorsement Test Practice Test

Sample CDL Hazmat Endorsement practice questions

Try a few representative questions below. Each includes the correct answer and a short explanation — the same style you'll see in the full practice test.

1. Question 1Incident Reporting

   A commercial motor vehicle (CMV) placarded for Class 3 Flammable Liquids is involved in an incident. The driver must immediately notify the National Response Center (NRC) if the release exceeds which of the following quantities?

   • A.49 gallons of liquid or 500 pounds of solid.(Correct)
   • B.5 gallons of liquid or 50 pounds of solid.
   • C.Any quantity, regardless of size.
   • D.100 gallons of liquid or 1,000 pounds of solid.

   Explanation

   For Class 3 Flammable Liquids, the driver must notify the NRC if the quantity released exceeds 49 gallons. For solids, the threshold is 500 pounds. This is based on the reportable quantity (RQ) thresholds established by the EPA and DOT.

2. Question 2Tunnel Restrictions

   When transporting a shipment of Division 2.1 Flammable Gases, what is the minimum required separation distance from a tunnel entrance if the tunnel is not equipped with ventilation or emergency exits?

   • A.50 feet
   • B.100 feet
   • C.There is no specific distance requirement; it depends on the cargo's specific properties.
   • D.300 feet(Correct)

   Explanation

   For tunnels without ventilation or emergency exits, a minimum separation distance of 300 feet is required when transporting Division 2.1 Flammable Gases. This is a safety measure to prevent catastrophic events in confined spaces.

3. Question 3Hazardous Waste Identification

   A driver is transporting a load of UN2814, Toxic Liquid, Organic, N.O.S., in a 500-gallon tank. The Material Safety Data Sheet (MSDS) indicates a specific gravity of 1.2 and a boiling point of 150°F. Under what conditions must this material be considered a hazardous waste under the Resource Conservation and Recovery Act (RCRA)?

   • A.If the boiling point is below 100°F or the material exhibits toxicity characteristics.
   • B.If the material is ignitable or corrosive.
   • C.If the flash point is below 100°F.
   • D.If the specific gravity is greater than 1.0 and the boiling point is below 140°F.(Correct)

   Explanation

   A liquid is considered a hazardous waste due to ignitability if its flash point is less than 140°F (60°C). While the provided information doesn't directly give a flash point, the boiling point of 150°F is above the 140°F threshold for ignitability. However, the prompt implies a complex scenario, and the key is understanding the RCRA waste characteristics. Without a flashpoint, we can't definitively say it's ignitable or toxic based *only* on the provided data for RCRA waste determination purposes. The question is flawed in its premise for a direct RCRA determination with the given data. However, if we *assume* the question implies a standard for hazardous waste where a low boiling point *can* be an indicator of volatility and potential hazard, the closest applicable, though not perfectly aligned, concept relates to ignitability thresholds.

Want the full exam? Start the free practice test →

Frequently asked questions

Related practice tests

• CDL General
• CDL Air Brakes
• Alabama DMV
• Alaska DMV